![]() Syntax information for bcdboot can be found at (v=vs.85).aspx You will probably have to use diskpart to assign the drive letters before running the bcdboot command. Something like "bcdboot C:\Windows /S s: /f UEFI" should do the trick (replace drive letters as appropriate, This example assumes C is the 213 GB partition that the Windows folder is located on and S is the 360 MB system paritition)Įasiest to run from the command prompt of either Windows 10 install media or the recovery tools, unless you have the ADK installed). Have you tried rebuilding it with bcdboot? While the Windows drive is selected, click on Clone this disk option at the bottom right. Normally, it would be C: drive but you can also see a Windows icon on that drive. My guess is the UEFI system partition is not setup correctly on the new drive and it can't find the Windows folder - especially since the uniqueid of the disk is certainly different and the size of the partition was changed. We will now begin the cloning process Inside the dashboard of Macrium Reflect, click on Disk Image from the left and select the drive where your Windows is installed. The partition structure looks correct for a UEFI-based Windows install which typically use GPT boot volumes. Also, this Slim PC has a really tiny mobo, uses laptop memory and a laptop style power brick.Īctually it is very likely that the source drive was a GPT formatted drive. I have cloned Windows 7 dozens of times and only had 1 non boot issue.Īnyone have any suggestions, something I may have overlooked. I worked on this from 2am till 9am this morning. I also tried doing an image of the drive and then restoring the image to the SSD and that failed as well, same error as the first time. ![]() I also turned off Secure Boot, turned on Legacy Boot, and all combinations of those two and still it won't boot. Run CHKDSK to check
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |